Mitsubishi Evo X Engine 4B11 EVO 10

  • 2300.00 £
  • Published date: October 28, 2024
    • Tintagel, Cornwall, United Kingdom

Mitsubishi Evo X Engine 4B11 EVO 10


⭕ Here I have a rebuilt Mitsubishi EVO X or EVO 10, it has been rebuilt and not run since.


Build spec:


· Wiseco forged piston set, 86.5mm, 9:1 compression ratio.

· Cylinder bores honed, cylinder block & head refaced.

· K1 H-section rods.

· ACL Raceline Main & Big-end bearings, ACL thrust washers.

· Standard cams.

· New standard turbo.

· Full gasket/ seal set.

· New timing chain.

Build also includes the following standard components:

· MAP Sensor

· Air temp sensor

· Crankshaft position sensor

· Camshaft position sensors

· MIVEC oil control solenoids

· Oil pressure switch (with separate -3 JIC male fitting for fitting a gauge or pressure sensor)

· Electronic Throttle Body


Some bits are missing off the engine and are listed below:

Fuel Rail

Injectors

Coils

Phone number ✆ 07978 820618
Tintagel, Cornwall




Related listings