⭕ Just came from a shop that recently closed. Good looking Femco thats ready to go right back to work. Desirable CNC lathe with a good reputation. All in all, a very functional CNC lathe. Comes with chuck and 5C Nose Piece.

Here is some information from Femco:

The 25E Double-Disk Turret design accommodates 23 tools, allowing for more tools than any other machine of its type in the industry. Double-disk turret provides faster set-up and increases time in cut. Instead of having to stagger the O.D. and I.D. tools, you can group your tool set-ups by workpiece and spend less time indexing. The 25E has the fastest chip to chip time in the industry, the bi-directional programming of the double disk can index O.D. tools on separate disks, further maximizing your cut time. Reduces average set-up time from 1 hour 20 minutes to 15 minute part to part.

FEATURES:
Fanuc Series O-T CNC control
Three Jaw 8 Hydraulic Chuck
Hydraulic Tailstock
Tool Turret
4,500 Max. Spindle RPM
Chip Conveyor
SPECIFICATIONS:
CAPACITY:
Max. turning length..................23.62
Distance between centers...........25.59
Max. swing over bed......................17.72
Max. turning diameter....................9.84
HEADSTOCK:
Spindle nose / internal taper..........A2-6 / 1/20
Spindle diameter at front bearing............3.94
Hole through spindle.................................2.40 dia.
Chuck diameter....................................8
Bar capacity.........................................2.05
Spindle speed....................................3500 / 4800 RPM
Spindle motor.....................................10 / 14.7 HP
TURRET:
Type / number of stations................Double disk / 12 x 2
Turret clamping force.......................5600 lbs.
Tool select...........Bi-directional programing w/ automatic selection of shortest route
Turning tool size...O.D. turning - 3/4sq. / I.D. boring - 1 1/4
X -AXIS:
Travel....................5
Rapid traverse rate...........787 in/min
AC servo motor................0.8 HP
Diameter of ball screw............. 1.10 x P0.24
Z -AXIS:
Travel.....................24.80
Rapid traverse rate...........944 in/min
AC servo motor................1.2 HP
Diameter of ball screw............. 1.26 x P0.31
TAILSTOCK:
Quill diameter................2.95
Travel..............................3.94
Taper..............................#4 Morse Taper
Axial thrust of quill.............1200 lb @ 290 psi
GENERAL:
Overall Dimensions: 51 x 120 x 67 tall
Power: 230 volt, three phase


Made by Femco Inc.
This is a CNC Turning Center in good condition!
Model # DURGA - 25E
Serial # L5ECXXX