⭕ It is a low mileage machine and has been carefully reconditioned. I disassembled, cleaned and painted all parts. I installed brand new bearings throughout including the table cranks, the spindle, and the motor, a new belt, new electrical wiring and a good assortment of new tooling.
There is approximately .015 backlash on the X and Y axis and the slides are smooth and even over the full length of travel. The table has a few small dings and a spot that looks like it was touched by a cutter, very superficial. There is no other damage and there are no cracks or welds on any of the castings. Overall condition is an 8 or 9 out of 10. The spindles are both smooth and quiet and the vertical spindle brake is very crisp and responsive!


This high quality made machine by Rockwell combines horizontal and vertical milling capabilities with the following features and accessories:

Rockwell single phase 1 ½ hp reversing motor- horizontal spindle-Low Voltage Starter, 220 volts
Rockwell single phase ½ hp reversing motor on the vertical head-drum switch, 120 volts
6 ½ x 24 table
R8 spindle-Vertical
NMTB 30-Horizontal
4 Kurt style angle lock vise
6 speed step pulley head-Vertical- 2440, 4420, 6300 RPM
Back Geared 12 speed-Horizontal-60, 135, 240, 300, 385, 1875, 2400 RPM
¼, 3/8, ½, ¾ R8 collets from Grizzly
Draw bar wrench
Work light
Small assortment of cutters
0-½ Jacobs chuck with key (new)
2 ¼ x 1 ½ High Speed Steel Shell Mill mounted on NMTB 30 arbor (new)
1 end mill holder on a NMTB 30 arbor
1 milling arbor with spacers
Photocopy of the operators manual
3 diameter hard chrome plated quill, 2 ½ stroke
Worm and worm gear controlled tilting head
16 longitudinal table travel
6 ¾ cross table travel