⭕ Boeing 502-10 Gas Turbine Engine, custom Turbojet conversion, with full after-burning nozzle. Produces 375 lbs of thrust without afterburner and 600 lbs with. Weighing in at approximately 150 lbs.

Turbine has recent service. Cleaned and detailed. New Fuel and Oil Filters. Many new hoses, lines, and fittings. Oil sumps and screens cleaned. Combustion can liners and fuel nozzles cleaned. Compressor and power turbine blades inspected and washed.

Included:
-Boeing 502-10 Turbojet Turbine
-High Pressure Fuel Pump and Fuel Metering Device
-Two Igniters
-Starter Generator
-Fuel Filter
-Oil Filter
-After-burning exhaust nozzle (Explained in full detail below)
-3 removable lifting tabs
-Gearbox Breather Filter
-Custom Aluminum Intake Screen
-Fuel Solenoid
-Throttle Lever
-Tachometer Generator

Afterburner Features:
-304 Stainless Steel Construction
-Inner cone and support
-Primary Spray Nozzle
-Secondary Pilot Nozzle
-Flame Holder
-Igniter
-Fuel manifold with -4 an inlet
-Detachable outer cone with flanges
-Egt probe and bung installed
-High Heat Coating Applied

Dimensions:
-54 Long from the front of the intake screen to the rear of the nozzle
-24 Wide at the widest point which is the round compressor housing
-26 Tall from the base to top of the compressor housing
-Intake screen is 8.5 long if you want to remove for space restricted installs

This is an absolutely beautiful and clean turbine. Would be a great power-plant for a go kart, motorcycle, aircraft, etc. A great opportunity to get a top notch turbine with afterburner. All the guess work and hard work has been completed.