⭕ This is a complete turn key Land And Sea 800 horsepower engine dynamometer system, it has many options with it including the Pro Control Console with a larger monitor, a high flow 1 auto load servo valve (valve has only been used to dyno maybe 6 engines), weather station which Land And Sea just overhauled, Dyno Max Pro 2010 software loaded onto a Dell desktop computer. We have used this dyno for about 4 years now and the only reason we are selling it is to be able to do larger high horsepower engines. We have dynoed Chevy SB2 engines that have made 840 horsepower and turned over 9000 RPM without an issue and have done many GM crate engines. Unit has a 13 water brake and is the Toroid version. This setup includes everything you need to dyno an engine, comes with a Dayton 7.5 horsepower 3 phase pump, all the 1.5 galvanized piping to pipe into the control panel and back out to the brake, throttle cable is roughly 25 long, has all the PVC that we ran all of our wiring out of and through for batteries, fuel pumps etc. Sensors included are water temp, oil temp, fuel pressure and fuel flow transducer, oil pressure, weather station, 8 EGTs, turbine shaft sensor. Was checked and serviced. The main wiring harness that feeds all the sensors from the control box that houses the boards has also been replaced recently. This dyno has been well cared for and is a turn key system just supply a tank. It will come with all the hoses and quick connect for the cooling tower and the brake. We have also fabricated different mounts for engines with a front motor plate that does not have mounts. We have had Chevy, Ford and Chrysler engines on it so all the mounts and adapters for mounting are there, I also have some misc bellhousings and flywheels that will go with it. Can assist to deliver.