⭕ This is a used Evinrude 250 High Output direct injected 20 standard shaft 507 pound engine is ready to go!


THE H.O. SERIES - BLURRING THE LINE BETWEEN BOATING AND AVIATION.


Then take a closer look at the ETEC High Output Series because they push limits about as far as they can go and come with everything it takes to handle it.

From the high-performing SLE (Straight Leading Edge) gearcase with nose-cone pick-ups that significantly increases water flow to the engine and provides increased cooling ability and capacity to the high-quality gears with super pure, extra-tough metallurgy and stiffer engine mounts for superior handling and control at high speeds.


No matter the application, the H.O. series gives you the maximum performance youre looking for while fulfilling the need for speed.

Its the combination of lightweight and high torque that make E-TEC accelerate faster and achieve higher top speeds than almost any other outboard in its class. 90° V6 with 3.4 liters of displacement for the ultimate in power and torque.


One of the cleanest engines in the world while using less fuel and running quiet.

This engine can be ran full-throttle from day one!




Since this engine is used it comes with full Factory warranty thru September 10th 2012

Engine only. No controls or prop is included with this sale!


Shaft Length 20
Dry Weight 507 pounds
Type V6 90° E-TEC DI
Bore and Stroke 3.854 x 3 in / 98 x 76 mm
Displacement 210 cu in/3441 cc
Starting Electric
Trim Method FasTrak Power Trim and Tilt
Rated Power Factory Tuned For Performance
Full Throttle RPM Range 4500 to 6000 RPM