⭕ Transfluid Series K mandrel bending machines are especially compact, powerful and reasonably priced bending machines that are controlled fully hydraulically. Up to 8 bending angles can be preselected digitally (target value), displayed permanently as the actual value and switched off. Additional functions (cutting ring pre-assembly, flaring, de-burring, sawing and chamfering) can be integrated.

Max. round tube size - inches (mild steel) 2 x .120
Max. steel pipe - Sch. 40 1-1/2
Max. square tube size - inches (mild steel) 2 x .120
Max modulus of section 5,0 cm3
Max. center line radius 5
Tube arbor length 10/15/20
Bending speed 90 degrees (forward only) 8 sec.
3 HP
Bending angle max 190 degrees
Bending direction right
Number of digitally programmable bends 8
Size in inches (without arbor), L x W x H 44 x 36 x 51