ESAB CNC LOW RAIL HYDRO CUT WATER JET PLASMA TABLE

  • 9999.00 £
  • Published date: September 23, 2024
    • Alcombe, Somerset, United Kingdom

ESAB CNC LOW RAIL HYDRO CUT WATER JET PLASMA TABLE


⭕ ESAB CNC LOW RAIL HYDRO CUT WATER JET / PLASMA TABLE

2001 ESAB CNC Low Rail Hydro cut profiling table 6m x 2.5m with water bed

Cutting equipment:
The table is equipped with one 200amp ESP Plasma torch c/w power source, capable of piercing 25mm MS and has an edge start cutting capability of up to 35mm. It is also equipped with a waterjet capable of cutting material up to 200mm thick, this is powered by a 50hp 3 phase Ingersoll Rand pump.


The machine can be configured to use a combination of the above cutting equipment in order to take advantage of their respective benefits within one nested cut on a single plate.


The working dimensions of the table is 6m long and 2.5m wide with a low x axis rails to allow easy loading and unloading of plate etc.


Included is a 3 phase screw compressor, air drier and 1000lt receiver for the plasma. All wiring, starters, isolators, main distribution board and pipework, ready to re-fit.


The table has a built in computer controller which is included.

Phone number ✆ 01458 900907
Alcombe, Somerset




Related listings