⭕ The Stringing Gun EZ50 by Zeitler is used to feed a special pull line promptly and efficiently into conduits of Ø 18 to 50 mm (internal diameter) for electrical installation in private construction.

Easy to apply even in buckled conduits, junction boxes, sockets and plugs.

The simple way to blow or suck pull line.

Facts
• Blow or suck pull line without compressor
• For all commercial pipe work
(internal diameter from 18 to 50 mm)
• Appropriate for flexible conduits
• Installations in the range of private,
office and industrial buildings
• Huge time saving in cable feeding
• Feeding of several hundred meters
• Lightweight and compact
• Excellent accessibility, even in confined spaces
• Easy to handle
• Double function (blowing and suction mode)
• Perfect and strong to solve pull line
feeding problems
• Suitable in any car boot
• Perfect value for money

Zeitler AG
Stringing Guns and Cable feeding Tools
Sonnhalde 7
CH-6206 Neuenkirch/Switzerland
Tel. +41 (0)41 467 16 14
Fax +41 (0)41 467 20 35
www.zeitler.ch

Stringing Gun EZ50
for all electrical installations
Intended Use:
• insert a special pull line in all commercial conduits (int. ø 18 to 50 mm)
• installations in the range of private houses, office and industrial buildings
• for all commercial boxes, junction boxes, sockets, lamp boxes etc.
(even in very confined spaces)
• problems with f.e. kinked conduits can be solved by switching to suction mode,
sucking the pull line from opposite end
Function:
• apply line brake
• fit joint/nozzle appropriate to internal conduit diameter
• firstly blow through the conduit with air, check if penetrable tube/correct tube
• make either a loop or fix a bead to the pull line
• release line brake
• blow pull line in without interrupting, observe uncoiling in cylinder
• release switch and close nozzle with a finger
• apply line brake and cut off pull line
• fix wire/s to the pull line and start pulling

Stringing Gun EZ50
Standard equipment in strong plastic case

• 1 Stringing Gun EZ50
• 2 pull line rolls ø 1 mm, approx. 900 m, tensile strength approx. 24 kg
• 1 suction device
• Components set A: 2 joints ½, reduction 19/12 mm and nozzle int. ø 9,5 mm
• Components set B: 3 joints ¾, nozzle int. ø 16 mm plus nozzle int. ø 19 mm
• 1 special nozzle black, for internal diameter from 25 to 50 mm
• 1 special nozzle with 90° angle, external diameter 12 mm
(only in connection with special nozzle black)
• 3 beads of ø 11, 13 and 16 mm each
• Operating instructions

https://www.youtube.com/watch?v=dRyEW355ZHk