Boxford T220 CNC Lathe With Rotary Tool Post

  • 1300.00 £
  • Published date: October 24, 2024
    • Kent, Kent, United Kingdom

Boxford T220 CNC Lathe With Rotary Tool Post


⭕ Boxford T220 CNC lathe with 8 position rotary tool post.

Rare on the second hand market this machine is out of a City Learning Center and has seen very little use since it was supplied new in 2005.

The machine is in as new condition having been used only once in the school.

You would be have pressed to find a machine in such a good unused condition.

BUT no software is included as this was licenced to the original user who have retained it. YOU must contact Boxford to check on the availability and cost of replacement software.


If you dont fancy using Boxford software this would make a great MACH3 project as you could re use some of the electronics and wiring.

Specification

Swing over bed 210mm

X Axis travel 150mm

Z Axis travel 350mm

Distance between centres 400mm

Spindle bored to pass 25mm

Spindle motor .75 Kw

Spindle speed 200 - 3500rpm Electrics 230v 1 PHASE

Programmable feed (linear and circular interpolation modes) 0-1000mm/min

Rapid feed rate at 100% 1000mm/min

Linea rails on all axes.

8 Position programmable rotary tool post (turret) with four external positions (Max 10mm shank tooling) and four internal tool positions (Max 10mm Dia shank)

100mm 3 Jaw chuck with key

Lockable cabinet with key


NOTE cabinet is integral to the machine, No coolant fitted but does have the internal pipe work fitted so retrofitting flood coolant would be easy.

Has its original tooling fitted in the turret which comprises Left hand and right hand turning tools, Threading tool (metric inset fitted), Parting tool, 10mm 5mm drills centre drill and 10mm boring bar. All tools except the drills have replaceable carbide tips and are branded (iscar, stelram, sumito, Dormer)

Phone number ✆ 01622 984232
Kent, Kent




Related listings